Navigating and Saving A Preset - V1.12 Firmware.
PRESETS EXPALINED
V2.01 firmware (OCT 2026)
Colortone now provides 3 fully editable and Saveable presets in its new v2.01 firmware. 10 Presets are available via MIDI.
Navigation between the 3 presets is made by pressing both footswitches together the presets will cyle from Preset1 = RED Rate LED Preset2 = Green Rate LED Preset3 = Amber Rate LED.
Saving the current preset is performed by pressing the TAP Footswitch for two Seconds. The RHS LED will blink twice to confirm the same.
NOTE the pedal will now start up after a power cycle in the last used preset.
V1.10 firmware.
COLORTONE provides three presets on their 2025 pedals.
Navigation / Cycling of the three presets is achieved by momentarily holding down both footswitches. Each dual footswitch action will cycle to the next preset. When the preset is successfully changed the Tempo LED will change color to indicate which preset is active.
Preset 1 = Green Tempo LED
Preset 2 = Red Tempo LED (Free Mode) Default Startup Preset
Preset 3 = Amber Tempo LED
The default startup preset is Preset 2 (Red LED). Preset 2 is the only live preset with all the control functions active. The settings from Preset 2 can be saved to either of the other presets .
NOTE The recalled settings in Preset 1 and Preset 3 are not editable while selected except for tempo which can be momentarily updated via the tap tempo function. (MIDI controllers can override preset settings with CC controls or a MIDI expression controller). If you need to tweek the preset you will have to remake it in Preset 2 and then save / overwrite those settings in your desired preset or use MIDI.
SAVING A PRESET
Craft a set of settings you like in Preset 2. Then Cycle to the Preset you wish to save to. Press and Hold down the Left Hand Footswitch until the RHS LED Flashes green. You have now overwritten that preset with the settings you just made in Preset 2.
