Important Firmware Update for ZeroSum and VibroVerb - V1.11H

Firmware updates are now available for both the ZeroSum and VibroVerb pedals which addresses some important updates and operational bugs reported by customers.

V1.11h General BugFixes and Updates for BOTH VibroVerb and ZeroSum Pedals

• Fixed - Some units not saving and recalling presets correctly after a power cycle

• Fixed - reported accidental save of preset when switching between presets using the new dual footswitch cycle

• Update - Added smoother scaling of Sine Q waveshaper tool for those looking for a harder modulation pulse/throb. (Only available for the Sine Wave)

• Fixed - Reduced background soft 6k Hum/noise found in some pedal/amp combo setups - See Below for ZeroSum Updates.

VIBROVERB UPDATES

• VibroVerb_v1.11h RELEASE

• Includes the General updates notes above

ZEROSUM UPDATES

ZeroSum now has two Firmware variants - 625ms and 1000ms

• 625ms Version

  • ZeroSum_v1_11h_RELEASE - 625ms

  • All background noise removed which at high levels could appear as a 6k ‘whining’ sound.

  • Maximum delay time is now 625ms

  • In addition Mode C on the Single Head has been updated to a ratio of 2:1 where the RHS repeats at a rate double of the LHS

  • Also includes the General updates and bug fixes noted above

• 1000ms Version

  • ZeroSum_v1_11h_RELEASE - 1000ms

  • Maximum delay time is 1000ms

  • Identical to the original version but also includes the General updates and bug fixes noted above

Video instructions & firmware files are available here with step by step instructions on the Colortone Firmware Updater Website.

Updated Manuals and Quickstart guides are available here.